Fret seating problem

Fret seating problem fret slot depth Later sanding? With frets installed? no- I slot, then glue the FB on, then sand level etc, then fret fret slot depth Be sure your fretwire will fit! Don't wait until after you've installed a fret to discover the slot wasn't quite deep enough Dan Erlewine developed this

fret slot depth Be sure your fretwire will fit! Don't wait until after you've installed a fret to discover the slot wasn't quite deep enough!Not sure if your fret slots are

fret slot width What is the nominal fret slot width? If you target is , you will not get that with a cutter If your target is , you might I tried wide Then program a 3D finish path cutting the same direction as the fret slot I had to play around with the stepover to get a