'Tab and Slot' Self-Locking Ring: What is it, How Does it Work, and

When I have multiple instances of a part in an assembly and I go in to configure a Tab & Slot feature on one of them The Tab gets copied

Assuming the tab is flush with the outside surface of the slot, I would classify it as a square groove Two arrows would be required to weld

tab and slot Normal Cut in Tab and Slot When you use the Tab and Slot tool, you can specify that the slot is normal to the sheet even if the tab is at an angle to the slot

tabletop slot machine 005- 010 over the thickness for the width of the slot for cold rolled I normally make the slot longer than the tab by about 050 After